Goya Custom 4 Pro Board

Note: online exclusive – please call to check supplier levels

CUSTOM 4 PRO

SURFWAVE QUAD

The latest Custom 4 Pro from our world champions Marcilio Browne, Maria Morales, Marino Gil and Francisco Goya. The Custom 4 Pro is the ultimate Pro Model custom wave board, as it is not just the shape but the same off-the-shelf board our team chooses to ride and compete on.

The outline on these new quads grew slightly in the nose and tail areas. Compared to the previous generation, the rail profile has been filled on the nose and thinned towards the tail.

The new rockers were adjusted to balance those changes, incorporating a fast surfing rocker that can still fit into the curve of the wave, whilst maintaining the early planing that will accelerate into any ramp or turn.

Bottom shapes seamlessly transition from panel V below the mast foot for added rail to rail and off the top rebounds, to Double Concave between the stance for a faster slippery bottom shape and then fading into a Single Concave in the tail for the ultimate turns.

Rockers, inserts and constructions are customized to each size, suiting the rider and the conditions that the board will be used on, yet the Custom 4 Pro brings you the most rocker in the Goya Windsurfing board range.

The new Goya Windsurfing boards now come packed in recycled cardboard and paper tape only. No plastic bags. Keeping your planet, our planet, one step cleaner. We figured it’s a worthy trade off, as our love for windsurfing and the planet only grows.

• PWA World Tour Approved.

• Pro Construction, Full Carbon & S-Glass Hull.

• Available in 54, 60, 68, 74, 79, 84, 89, 94, 104, 114 liters.

• Comes with the latest generation MFC footstraps.

• 3rd Gen. Slot Boxes.

• Available in Fluo Yellow & Bright Red.

• High Density Full Double Sandwich.

Vent Plug Screw –

This board comes with a vent plug screw that tightens onto a rubber seal ring. It is very important that the screw has been tightened before you use the board, and it’s equally important that it’s been removed before the board is transported by air, for example in your car, in summer, with the windows rolled up.

The screw needs to be tightened enough to seal the board, but not to where it might damage the rubber and/or the vent thread. Do not use power tools.

Make sure the rubber is not damaged and clean before installation. You can rinse it with fresh water. Do not get any water into the seal itself.